5.5" RADIUS ARM LIFT KIT W/ NITRO SHOCKS 13-18 RAM 3500 GAS - D67N

ZONE 5.5" REPLACEMENT RADIUS ARM LIFT KIT WITH FRONT COILS AND REAR BLOCKS WITH NITRO SHOCKS | 13-18 RAM 3500 GAS 4WD

• Progressive rate front coil springs improve ride quality and off-road performance.
• Radius arm drop brackets to correct caster and improve suspension geometry.
• Forged pitman arm and track bar relocation bracket to correct steering angles and recenter front axle.
• Extended bump stops, sway bar relocation and brake line relocation to maintain factory-like operating angles.
• Replacement rear lift blocks and u-bolts to lift and level the stance.

Important Note: Front drive-line vibration may occur at speeds over 35 mph when in 4WD. If this occurs, install the appropriate optional t-case indexing kit. Models with a 6 bolt transfer case use ZON-D5623. Models with an 8 bolt transfer case use ZON-D5813. Does NOT work for models with factory rear airbag suspension. Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.